EGW's Mosin Nagant mount allows you to remove the rear leaf sight and install the base without the need to unsolder anything. It is one of the most stable bases on the market and uses the rear sight housing so there are no major modifications to your rifle like with some other brands. Installation: Remove rear leaf sight from the housing Keep the original pin as you will need this to install the base Insert the tabbed side of our steel base in to the rear of the rear sight Check for fitment on the front of the steel base The corners and front may need to be filed down to achieve the optimal fit Once the base sits completely in the rear housing insert the retaining pin from the original sight Adjust the set screw to take up any play in the rail Screw the top aluminum mount to the steel base This mount can be put on in either direction EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions they have published. Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. EGW one-piece scope mounts are the obvious choice for hunters and tactical shooters alike. EGW machines these in thier shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type III anodized for long lasting durability. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately).
Kraftig og stabil Montasje for Mosin Nagant
EGW's Mosin Nagant montasje lar deg fjerne den bakre bladvisningen og installere basen uten behov for å lodde noe. Dette er en av de mest stabile basene på markedet og bruker bakre siktehus, slik at det ikke er noen store modifikasjoner på riflen din, slik som med andre merker.
Installasjon:
- Fjern bakre bladvisning fra huset.
- Behold den originale pinnen, da du vil trenge denne for å installere basen.
- Sett den flate siden av vår stålbase inn i bakre del av det bakre siktet.
- Sjekk for passform foran på stålbasen.
- Hjørnene og fronten kan måtte files ned for å oppnå optimal passform.
- Når basen sitter helt i bakhuset, sett inn beholderpinnen fra det originale siktet.
- Justér setteskruen for å ta opp eventuell bevegelse i skinnet.
- Skru den øverste aluminiumsfestet til stålbasen.
Denne montasjen kan settes på i begge retninger. EGW anbefaler å måle hullavstanden i mottakeren din for å bekrefte at den samsvarer med dimensjonene de har publisert.
Picatinny-krysslottene går over hele lengden av skinnet, noe som gir skytteren fleksibilitet når det gjelder montering av kikkertsikter og andre tilbehør. Kanalen i midten reduserer den totale massen av montasjen. I mange tilfeller vil det heller ikke hindre bruken av fabrikkens jernvisninger. EGW's en-dels kikkertsikter er det åpenbare valget for både jegere og taktiske skyttere.
EGW maskinerer disse i sin verksted ved hjelp av en av sine maskineringssentra. Etter maskinering blir montasjene tumlet, sandblåst og Type III anodisert for langvarig holdbarhet.
Installasjon:
EGW anbefaler 20 tommer lbs med dreiemoment og en dråpe blå loctite (loctite selges separat).